爱克赛蓄电池充电性能解说：
爱克赛 蓄电池应采用限流恒压充电方式进行充电，即充电初期应控制电流在0.3c以下，当出电池端电压到规定恒压值时，改用规定的电压值恒压充电到结束。
如果爱克赛 蓄电池经常期搁置，在使用前应对蓄电池进行补充电，充电规则如下：
储存时间3-6月，充电电压单格2.45 最大充电流0.3c 充电时间24h 充放电次数为2-3次。
储存时间6-12月，充电电压单格2.45 最大充电流0.3c 充电 时间36h 充放电次数为3-4次。
在补充电时对储存时间较长的爱克赛 蓄电池应进行适应的充放电循环，放电深度在20-40%为宜，循环次数不少于3次。
充电电流低于0.005c充电后期连续3个小时电流保持不变。
Explanation of charging performance of Exeter battery:
Axel battery shall be charged by current limiting and constant voltage charging mode, i.e. the current shall be controlled below 0.3C at the initial stage of charging. When the voltage at the battery outlet reaches the specified constant voltage value, the specified voltage value shall be used for constant voltage charging until the end.
If the axel battery is put aside regularly, the battery shall be recharged before use. The charging rules are as follows:
The storage time is 3-6 months, the charging voltage is 2.45, the maximum charging current is 0.3C, the charging time is 24h, the charging and discharging times are 2-3.
The storage time is 6-12 months, the charging voltage is 2.45, the maximum charging current is 0.3C, the charging time is 36h, the charging and discharging times are 3-4.
When the battery is recharged, the battery with a long storage time shall be charged and discharged in a suitable cycle, with a discharge depth of 20-40%, and a cycle number of not less than 3.
The charging current is lower than 0.005c and remains unchanged for 3 hours in the later stage of charging.
